Open the /etc/nf file with Vim: sudo vim /etc/nfĪnd add vm.swappiness = 10 at the very end. If you have 8G or more of RAM, you can force your system to use it at maximum.įirst, check your swappiness value: cat /proc/sys/vm/swappiness ![]() Swap is an actual disk space and it is much slower than RAM. But if you decrease this number, your system will use RAM more and start writing to Swap much later. Swappiness is 60 by default which is fine in most cases. $ sudo ufw default deny incoming $ sudo ufw default allow outgoing $ sudo ufw allow ssh $ sudo ufw enable Be sure to add rules for ports and services we need as we go along adding containers and such. Most importantly we need to set up our firewall. Make the following changes (change to the name of your interface and what ip address you want): network: ethernets: ethernetname: dhcp4: false addresses: gateway4: 192.168.1.1 nameservers: addresses: version: 2Īnd then lastly follow up with a $ sudo netplan apply ![]() $ sudo vim /etc/netplan/00-installer-config.yml We need to set a static IP for the server on the network.Įdit our netplan config to do so. Its a oneshot service, which performs one task then exits. Example: On my Ubuntu server, the ufw service initializes the firewall at system startup. For example, if the unit file sets RemainAfterExittrue, a service that exits is reported as active. Take note of the name of your Ethernet interface. active (exited) is not a problem in itself. Install the holy trinity: $ sudo apt install vim tmux ranger -y $ ifconfig Things I always do on a fresh install $ sudo apt update & sudo apt upgrade -y The only additional selection needed is to install SSH. The current stack: Plex Sonarr Radarr Jackett Organizr QBittorrentVPN SABnzbd Prometheus Grafana People interested in importing ‘GenericCloud’ images into their own cloud solution can find corresponding images on the link above. These images are built and made available for all the architectures that corresponding version supports. We maintain our anonymity when using public torrent trackers as well as maintain normal download and upload speeds outside of the container.įirst, we need a fresh install of Ubuntu Server. We build, maintain and update Cloud images that you can find on our Cloud Images server. ![]() On of the things I love about this build is that we can run a VPN through the torrent container only. It simplifies the process of downloading from Usenet dramatically, thanks to its friendly web-based. The server we are going to make will automatically handle requests with Sonarr or Radarr, download them via usenet or torrent, then load them into Plex for viewing. SABnzbd is an open-source cross-platform binary newsreader. What a fool I was to be doing all that work! I could have been automating everything with Docker the whole time. I had run a Plex server for my house in the past, but I was managing it manually. For RHEL5/6, SABnzbd requires packages available in EPEL ( what is EPEL, Using EPEL ): par2cmdline, python26 for RHEL5, etc. Third-party repositories SABnzbd requires unrar from RPM Fusion or ATrpms. I stumbled onto some self hosting subreddits, watched a few videos about Portainer and had to try it out for myself. Once installed, you can start SABnzbd by typing SABnzbd in a terminal or in the gnome (KDE) menu (Internet->SABnzbd). I’ve been meaning to set up an Ubuntu server to run some docker containers as a personal project for some time.
0 Comments
Leave a Reply. |